Solar Battery System
Product Features
1. 12kW EPS Output
2. 10 units Paralleling
3. AC Couple to retrofit existing solar system
4. Support Wi-Fi for mobile monitoring
5. 3 MPPT Input for max input 18kW
6. Separated Generator Input
7. 200A AC Passthrough Current
8. PV Module Monitoring
9. Peak Shaving Function
10. Color LCD, Touch Scree
A home solar power system is a kind of power generation system that converts solar energy into electric energy.
The household power generation system is generally composed of photovoltaic arrays composed of solar cell modules, solar charge and discharge controllers, battery packs, off-grid inverters, DC loads and AC loads. If the output power supply is AC 220V or 110V, an inverter is also required. The photovoltaic array converts solar energy into electrical energy when there is light, supplies power to the load through the solar charge and discharge controller, and charges the battery pack at the same time; When there is no light, the DC load is supplied by the battery pack through the solar charge and discharge controller, and the battery also directly supplies power to the independent inverter, which is inverted into alternating current through the independent inverter to supply power to the AC load.
Key features:
1. The single-chip microcomputer and special software are used to realize intelligent control;
2. Accurate discharge control using the battery discharge rate characteristics correction. The final discharge voltage is a control point corrected by the discharge rate curve, which eliminates the inaccuracy of simple voltage control overdischarge, and conforms to the inherent characteristics of the battery, that is, different discharge rates have different final voltages.
3. Fully automatic control with overcharge, overdischarge, electronic short circuit, overload protection, unique anti-reverse protection, etc.; None of the above protections will damage any parts and will not burn the insurance;
4. The series PWM charging main circuit is adopted, which reduces the voltage loss of the charging circuit by nearly half compared with the charging circuit using diodes, and the charging efficiency is 3%-6% higher than that of non-PWM, which increases the power consumption time; The over-discharge recovery of the lifting charge, normal direct charge, and floating charge automatic control mode make the system by a longer service life; At the same time, it has high-precision temperature compensation;
5. The intuitive LED light-emitting tube indicates the current battery status, allowing users to understand the use status;
6. All controls are industrial-grade chips (only for industrial-grade controllers with I), which can run freely in cold, high temperature and humid environments. At the same time, the crystal oscillator timing control is used, and the timing control is accurate.
